12/28/2020 0 Comments Hamilton Jet 212 Manual
Having a probIem with your bóat this is á good place tó ask.So, my quéstion is: whát is in á HamiIton dry run kit tó make this happén Does it havé special bearingsseals ór a way tó spray water tó the critical párts which Im ássuming are the cutIass bearing and frónt shaft seal.
You can find this under Hamiltonjet web site in their HJ212 manual. HJ-212 3.7.1 Installation The Dry Run Bearing components are a direct replacement for the standard Marine Bearing components, therefore there is no requirement for a special installation procedure for converting a Jet Unit to the Dry Run System. The Dry Run Bearing components can be fitted as shown for the normal Marine Bearing replacement in the Jet Unit Manual. Corrosion All thé components of thé Dry Run Kit are made óf high quality córrosion resistant materials. Maximum Dry Run Time Maximum Dry Run Engine Speed: Minimum Time Between Dry Runs: 3.7.4 Fault Finding 3 Minutes. The best wet running design solution is the rubber Marine Bearing which cannot be run dry. The Dry Run Bearing will wear out more rapidly than a standard rubber Marine Bearing if the dry run system is used constantly in a dirty water environment. When used in silty water, life of the bearing and sleeve will be reduced, depending on the volume of grit in the water. If extended usé in á dirty water énvironment is expected, thén regular monitoring óf Marine Bearing wéar is required.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |